FilterFuge

CENTRIFUGAL OIL CLEANERS
(Previously Spin-Clean Site)

Model Sizing

There are 4 Basic Models
6 Different Builds


Model FF600

960 usg/hr

Model FF200

240 usg/hr

Model FF60

120 usg/hr

Model 25

60 usg/hr


Two additional builds are availble, FF25LE and the FF60LE. These units have the same flow and dimensions as the FF25 & FF60.
They are designed spcifically for non-engine applications such as biodiesel, waste vegetable oil, used engine oil cleaning.

 

Oil Level Control Base (OLCB)
The optional OLCB permits the centrifuge to be installed in any convenient location near the engine or tank. The OLCB controls the oil flow from the centrifuge, back to the engine or tank and ensures the centrifuge reaches maximum speed and efficiency. To accomplish this, the OLCB uses a very small volume of compressed air, approximately 0.02 SCFM. The OLCB is capable of receiving compressed air from any 5 to 400 psig source. If there is no compressed air available, it may be possible to use turbocharger air or air from a positive discharge blower. Instructions for this type installation are available from Industrial Diesel Products Inc.

Gravity Drain-Engine Mounting
For gravity drain without the OLCB, the centrifuge must be close-coupled to the engine sump or tank, using an unrestricted drain back into the engine or tank above the normal oil level. A crankcase door, inspection cover, etc. can be modified to provide a suitable oil return back into the engine or tank.

 


Home
Why a Centrifuge
How Does it Work
Why FilterFuge
Model Sizing
What Are the Advantages
How Efficient Is It
Request Info

INDUSTRIAL DIESEL
PRODUCTS INC.

Worldwide Procurement Solutions
7075 Tranmere Dr.
Unit 7
Mississauga, Ontario, Canada
L5S 1M2
Tel: (905) 362-0423 Fax (905) 362-5015
E-Mail:sales@dieselproducts.com